INSTRUCTION MANUAL
CUS60M Series
TDK-Lambda
<Page>
3
Block Diagram
4
Sequence time chart
5. Terminal Connection Method
Pay attention to the input wiring. If it is connected to wrong terminal, the power supply will be damaged.
Input must be off when making connections.
terminal must be connected to protective earth of the equipment in Class I installation.
Output current of each terminal pin must be less than 7A.
The output load line and input line shall be separated to improve noise sensitivity.
Do not apply stress to PCB, when connecting or removing connector.
Use input/output connector (housing) specified by the table below.
Use recommended crimping tool. Connector is not included with this product. (Refer to the following)
5/19
Input voltage
Output voltage
0V
Vout
0V
OVP sensing (
※
1)
Inp
ut on
OVP act o
n
In
put
off
Inpu
t on
OCP act on
OCP res
et
In
put
off
(
※
1) OVP sensing point
120%~
Control Circuit
Rectifi
er
Filter
Sw
it
ch
in
g Circ
ui
t
OVP
Circuit
Output
Sensing
Inrush Current
Limit Circuit
L
ine Fi
lt
er
Rect
if
ier
&
F
il
te
r
Photo-
coupler
OCP
Circuit
L
N
+V
-V
Input
85~265VAC
·
Fuse rating · Circuit topology , switching frequency
2.0A 100KHz
Output