DC535Y/DCZ535Y, DC655Y/DCZ655Y BOOM GATE USER
’S MANUAL
9
5. Electrical
Remote control
Button 1
Button 2
Button 4
Button 3
Fig.9
⚫
To add extra remote controls (Learning)
: Press the button
‘AN’ (see Fig.10 control board
scheme No.13) on the control board, a beeper will be heard, then press the remote control button
which you want to use, the beeper will ring again, press the same remote control button again, the
beeper will ring at 1/2Hz frequency and then stop, the last ring is continuous. Then the learning
process is finished.
Up to 25 remote controls may be used.
⚫
Erase remote controls:
To erase all existing remote controls, press and hold ‘AN’ button, the
beeper will ring, release the button once the beeper stops ringing. This indicates that all the
remote controls have been erased completely.
⚫
The remote control works in a single channel mode. With each press of the remote control button
the bar will open, stop, close or stop cycle.
DIP-switch (SW)
Position
DIP-switch
Function
1
ON
Limit switch mode is NC.
OFF
Limit switch mode is NO.
2
ON
Auto-close function is available.
OFF
Auto-close function is shut off.
3
ON
Programming / In this position the control board is in
programming condition, NOT USE condition.
OFF
Normal / In this position the control board can be normally
used.
⚫
Set the bar auto-close function
: (This feature can be selected to keep the bar stay open for
some seconds before it automatically closes. The auto-close time can be adjusted to between 0
and 44 seconds.) Please turn on the second and the third DIP-switch (see Fig.10 control board
scheme No.5
‘SW’) to ON position. Press the remote control button which has been programmed
to open the bar, with the bar in vertical position, wait a few seconds according to your requirement