27
Select Function
USB Thumb Drive with
Mini USB Port
Male Mini USB to
Female USB
—Advanced Functions
LOCK THE SYSTEM
SYSTEM SHUTDOWN
System Shutdown Shuts the TCS3000 down. You must cut power to the TCS 3000 and
reboot to turn the unit back on.
SYSTEM UPDATE
System Update allows you to upgrade the TCS 3000 Software. NOTE: Update process
does NOT change Weights & Measures settings or parameters.
Procedure to upload new software is as follows:
1)
Load new software upgrade to a USB thumb drive (dongle).
NOTE: The new software upgrade should be the ONLY file on the drive.
2)
Open the TCS 3000 register. On the front cover of the register, there are 2 mini
-
USB
connections.. Using a factory supplied USB cable, attach the thumb drive to the USB
port closest to the inside of the register. This port is the highest on the circuit board of the two.
See Figure 1.
3)
Plug the USB cable into the USB port, and then insert the USB thumb drive into the mating cable
(see Figure 1).
4)
Under Advanced Functions, locate System Update and press ENTER.
5)
The screen will display System Update, press MODE to continue with the update.
6)
If the thumb drive is not recognized or there is a faulty cable, the display will respond with NO
UPDATE DATA error message.
7)
Once the file is recognized, the operating system will begin the update process. This should
take approximately 4 minutes.
NOTE: Do not power down or pull USB thumb drive until the TCS3000 tells you to do so.
8)
You may remove the USB cable and close the TCS 3000 register once the Update is Complete.
FIGURE 1
