11
2800 Laura Lane
•
Middleton, WI 53562
|
800.288.9383
|
www.tcsbasys.com
10
11
Configuration
ENABLE SMART
RECOVERY? NO
STEP 2 Smart Recovery: Select whether to use Smart Recovery
Mode.
NOTE:
Smart Recovery is not available when DI3 (see
) is configured for an external
time clock.
Energy Saving
STEP 1 Delay on Powerup:
In the event of a power interruption,
entering a value (in seconds) that will delay the powerup of the
SuperSTAT.
DELAY ON POWERUP
010 SECONDS
ENTER ACCESS
CODE 248
STEP 3 Access Code: This screen will appear if you configured
an access code requirement for either the Programming
Setup or Clock and Scheduling Setup om the previous two
steps. Select an access code value (0 – 255) to access the
Programming Mode and/or the Clock and Schedule Mode.
The default value is 248.
REQUIRE CODE FOR
CLOCK/SCHED? YES
STEP 2 Clock and Schedule Access:
Select whether an access code
is required to access the Clock and Schedule menus.
NOTE:
Use dip switch settings to lock out access completely
(see
“Programming Keypad Access” on page
).
Keypad Access Code
STEP 1 Programming Access:
Select whether an access code is
required to access Programming Setup.
NOTE:
Use a dip switch to lock out access completely (see
“Programming Keypad Access” on page
REQUIRE CODE FOR
PROGRAMMING? YES
Setting Clock and Schedule
NOTE:
Access to the Clock and Schedule Mode can be completely disabled via dip switch settings (see
, or access can be restricted by requiring an access code (
).
The main screen displays when not in Programming Setup Mode or
CLOCK SETUP Mode. The SuperSTAT will revert to this screen if no
entries are made after 10 minutes.
From the main screen, press the CLOCK SETUP button on the keypad to
configure the settings.
TUE 07-04-23
9:00 AM
72F
ENTER ACCESS
CODE 000
If
the SuperSTAT has been configured to require an access code to
enter Programming Mode,
this screen will appear (
). If you enter the wrong code, the screen will revert
to the main screen.