9
DC
-
IN Power Outlet
The Serial to EWiFi Converter is powered by a single 12V DC (Inner positive, outer negative)
power supply and 1A Current. Connect the power adaptor to the AC power socket and put the DC
Jack plug into the outlet of device. The “SYS” green color LED will be ON when power is properly
supplied. Terminal Block 2 wires power supply is an option.
DC Power outlet
Reset Button(WIFI)
If any chance you forgot the login password, or have incorrect settings making converter inoperable.
When the power is on and the “SYS” LED light on, use a point tip to press this button and hold it and
wait for more than 25 seconds. All the parameters will be reset to the factory default.
LED Indicators
PWR(green):
After power on, this LED is always ON.
SYS (green):
LED is ON after power on, then start blinking per second a after system running.
POE(red):
for PoE (Power on Ethernet) indication if device with this function.
WIFI(red):
LED is ON after power on, then off a while. It starts blinking after Wi
-
Fi module is ON.
TX / RX (Red / Green)
：
：
：
：
Data sending or receiving indicator. When data sent out to the network
or receiving from the network, the LED will be blinking.
Antenna Connector
The connector for antenna is a standard reverse SMA jack. Simply connect it to a 2.0dBi dipole
antenna (Standard Rubber Duck). It is 50 Ohms impedance and can support 2.4GHz frequency.
Ethernet Port
The connector for network is the usual RJ45. Simply connect it to your network switch or Hub. When
the connection is made, the green color LED of Ethernet port will blink. When data traffic (Rx/Tx)
occurs on the network, yellow color LED will blink during data transferring.
