10
DC-IN Power Outlet
The Device is powered by a 12V DC (Inner positive, outer negative) , 1.0A power supply. Plugging
the power adaptor to the AC power socket and put the DC Jack plug into the outlet of the Device.
The “SYS” green color LED will be ON when power is properly supplied. Terminal Block 2 wires
power supply is an option.
Serial Port of RS-232/RS-422/RS-485
Connect the Serial data cable between the device and the Serial interface device. Follow the
procedure of web page configuration to set up parameters.
Wiring Architecture
1. RS-232
2. RS-422/RS-485
When you finish the steps mentioned above and the LED indicators are as shown, the
Gateway is installed correctly. You can check the Software Setup CD to find Utility to
setup the IP Address. To proceed with the parameters setup, please use a web browser
(IE or Chrome) to continue the settings.
