LOCATION OF INSTALLATION
This product can be installed in a bathroom but only in the area designated by the IP rating – Zone 3 – see location
information below.
WIRING
INSTRUCTIONS
The power supply to the towel radiator must be protected in accordance with applicable standard by a 30mA differential
Circuit-breaker, 16A rated. Before carrying out any connection tasks, cut off the power supply to the electronic regulator
using the circuit-breaker or the protection fuse in the power supply circuit. This appliance does not come fitted/supplied with
a fused plug. DO NOT wire/fit a plug to this appliance.
Means for disconnection having a contact separation in all poles must be incorporated in the fixed wiring in accordance with
the wiring rules.
Connecting the power supply cable to the mains (220-240V AC)
220v – 240V +10% - 10% 50Hz monophase power supply.
Warning: you need to connect the 2 wires of the supply cable to a connection black ensuring the mains polarity is followed
as below:
IMPORTANT: The wire in the mains lead are coloured in accordance with the following code:
Blue – Neutral
Brown – Live
The blue wire must be connected to the terminal marked with an N or coloured black.
The brown wire must be connected t the terminal marked with an L or coloured red.
WARNING: Never connect live or neutral wires to the earth terminal.
All fittings must be installed by a competent person in accordance with the current IEE Wiring Regulation (BS 7671). If in
doubt, consult a qualified electrician.
SAFETY INSTRUCTIONS
(to be read before operating the heater).
1.
CAUTION:
Some parts of this product can become very hot and cause burns. Particular attention has to be given
where children and vulnerable people are present. Children 3 years and younger should be continually
supervised when in close proximity to the heater. Children aged from 3 to 8 years shall only switch on/off the
appliance provided that it has been placed or installed in its intended normal operating position and they
have been given supervision or instruction concerning use of the appliance in a safe way and understand the
hazards involved. Children aged from 3 to 8 years shall not plug in, regulate and clean the appliance or
perform user maintenance.
2.
Keep the power cord away from the hot body of the heater.
3.
Indoor use only.
Suitable for indoor only. This product is rated as IP24. If the product is to be installed within a bathroom
it can only be located within zone 3.
Zone 0
Zone 1
The area inside a bath or inside the shower
The area above the bath to a height of basin.
This area requires low voltage and an IP67
2.25m (7’ 4””) from the floor. If the light is
rating.
240V then a 30ma residual current device
(RCD) must also be used to protect the circuit
in this zone.
Zone 2
Zone 3
An area stretching 0.6m (1’ 11””) outside the perimeter
Anywhere outside Zones 0, 1, and 2 and where no
of the bath and to a height of 2.25m (7’ 4””) from the
water jet is likely to be used. If there is a likelihood of
floor. In addition, it is good practice to consider the area
water jets being used for cleaning purposes in zones 1,
around a wash basin, within a 60cm (1’ 11””) radius of
2 and 3 a fitting rated a minimum of IP65 must be
any tap to be considered as zone 2
used.
