&
Safety information
Installation
Important! For electrical connection carefully follow the instructions
given in specific paragraphs.
• Unpack the appliance and check if there are damages on it. Do not
connect the appliance if it is damaged. Report possible damages
immediately to the place you bought it. In that case retain packing.
• It is advisable to wait at least four hours before connecting the
appliance to allow the oil to flow back in the compressor.
• Adequate air circulation should be around the appliance, lacking this
leads to overheating. To achieve sufficient ventilation follow the
instructions relevant to installation.
• Wherever possible the spacers of the product should be against a
wall to avoid touching or catching warm parts (compressor, con
denser) to prevent possible burn.
• The appliance must not be located close to radiators or cookers.
• Make sure that the mains plug is accessible after the installation of
the appliance.
Service
• Any electrical work required to do the servicing of the appliance
should be carried out by a qualified electrician or competent person.
•
This product must be serviced by an authorized Service Center, and
only genuine spare parts must be used. Please refer to the warranty
card for further information.
•
In
Q
ueensland Australia the Authorized Service Provider MUST hold
a
G
as Work Authorization for hydrocarbon refrigerants to carry out
servicing or repairs which involve the removal of covers.
Energy saving
• Don't put hot food in the appliance;
• Don't pack food close together as this prevents air circulating;
• Make sure food don't touch the back of the compartment(s);
• If electricity goes off, don't open the door(s);
• Don't open the door(s) frequently;
• Don't keep the door(s) open for too long time;
• Don't set the thermostat on exceeding cold temperatures;
• Some accessaries, such as drawers, can be removed to get larger
storage volume and lower energy consumption.
5
