TCL L32S6FS, Руководство по эксплуатации

Страница: 9 / 41

8
Getting Started
Network Settings
You can set up your TV so that it can access the Internet through your local area network (LAN) using a wired or
wireless connection.
Connecting to a Wired Network
1.
Press on the remote control, select Network > Internet connection and press OK/► to enter.
2. Press ▲ / ▼ to select On and press OK to confirm.
3. Press ▲ / ▼ to select Interface , then select Ethernet and press OK to confirm.
4.
Press
▲ / ▼
to select
IP settings
and press
OK/►
to enter. You can set
Address type
to
Auto
or
Manual
.
- Select Auto if you want the TV to acquire and enter the needed IP address automatically.
- Select Manual if you want to enter your IP address manually, then:
• Press ▼ to go to the first entry field.
• Enter the IP Address , Subnet Mask , Default Gateway , Primary DNS and Secondary DNS values. Use the
numeric buttons to enter numbers and the ▲ / ▼ / ◄ / ► buttons to move from one entry field to another.
- Once
IP setting
is completed, press
▲ / ▼ / ◄ / ►
to select
OK
and press
OK
to confirm. The set will try to
connect to the network and inform you about the result. Press to return to the Network menu.
Connecting to a Wireless Network
Your TV is equipped to be connected to your home network wirelessly. To do that you need a wireless router or
modem.
1. Press on the remote control, select Network > Internet connection and press OK/► to enter.
2. Press ▲ / ▼ to select On and press OK to confirm.
3. Press ▲ / ▼ to select Interface , then select Wireless and press OK to confirm.
4. Press ▲ / ▼ to select Wireless settings and press OK/► to enter. You can set the wireless network connection in
3 ways:
- a) Scan
• Press ▲ / ▼ to select Scan and press OK/ ► to enter. The TV will search all access points within range. Access
points found by the TV will be displayed.
• Press ▲ / ▼ to select an available access point, then press OK/ ► to connect.
• Press to return to the Wireless settings menu.
Note
: If you select a protected access point, you will have to enter the corresponding password. Press
OK
on the
remote control to display the virtual keyboard to enable you to enter the password.
- b) Manual
Press ▲ / ▼ to select Manual and press OK/ ► to enter. You will be prompted to enter the correct SSID of an
available wireless router to set up the connection. Press to return to the
Wireless settings
menu.
- c) Auto
If your AP (Access Point) supports WPS (Wi-Fi Protected Setup), you can connect to the network via PIN
(Personal Identification Number) or PBC (Push Button Configuration). WPS will automatically configure the
SSID and WPA key in either mode.
Press
▲ / ▼ to select Auto and press OK/ ► to enter.
• PIN : Select PIN and press OK/ ► to enter. Choose a random PIN code. Make sure this code is installed on the
AP. (For the procedures, refer to your router manual.) Select OK and press OK to set up the connection.
• PBC : If your router has a PBC push button, select PBC and press OK/ ► to enter. Press the PBC push button
on your router within 2 minutes before you select OK and press OK again. Your TV will automatically acquire
all the network setting values it needs and connect to your network.
• Press to return to the Wireless settings menu.
- Press to return to the Network menu.
5. Press EXIT or to close the menu.