33
PANEL INSTALLATION
The panel should be installed after the pipwork and wiring have been connected.
Following installation ensure that the gaps between the panel and the ceiling are sealed to
prevent air and liquid leakage.
1. Push the two grill switched towards the
centre to unhook the grill before pulling the
centre of the panel downwards to remove it
from the panel.
2. Hold the grill at a 4
5̊ angle to the unit and lift
to unhook from the rear of the panel.
3. Hold the panel against the cassette
unit, lining up the red arrow on the
electrical box with the one on the
panel, before loosely fastening with
the M6 bolts.
4. Connect the cables for the step
motors and display panel to the
cassette following the wiring diagram
provided, ensuring that the cables will
not get trapped when tightening the
panel.
5. If the optional wired display panel is also to be installed, it should be also be connected to the
cassette at this point.
6. Check the position of the panel before fully tightening the bolts, so that the panel is flush to the
cassette unit.
7. Reattach the Grill to the panel following the reverse of removal.
8. If there is a gap between the panel and the ceiling after tightening the screws, readjust the
height of the cassette, ensuring it is kept level.