TC Electronic RebelHead450, Руководство пользователя

Страница: 15 / 22

The optional RebelControl footswitch not only allows you to
remote access the RebelHead’s three memory locations (MEM
1/2/3), but also to mute the signal for silent tuning and even view
the tuner information. No power-supply is needed for the
RebelControl as it receives its power from the RebelHead amp.
1 – Memory Switches 1, 2 and 3
Press one of the three numbered buttons to recall the settings
stored in the associated MEM-location. A green light ring around
the switch indicates that this MEM-setting has been recalled (activated).
–
Note that you can only recall a MEM-setting if a setting has
actually been stored in a memory location.
– Also note that as soon as you change one of the stored
settings on the RebelHead front panel, the green light ring
on the footswitch will be unlit. This indicates that the
positions of the front panel knobs no longer correspond with
the stored settings.
2 – MUTE button
Press the M(ute) button to mute the RebelHead’s outputs. This
is useful for tuning or e.g. unplugging/changing your bass.
The MUTE button also mutes the RebelHead’s
balanced output, allowing you to tune silently, even
when connected to the PA system.
3 – DISPLAY
The display always indicates tuner information in a couple of
different ways. The detected note is shown on the left side. On
the right side of the display, a circle indicates that the note is in
tune, an arrow pointing to the right indicates that the note should
be tuned up, and an arrow pointing to the left indicates that the
note should be tuned down. In addition to these indications (that
are also shown on the RebelHead tuner display), a line of nine
dots below the display indicates how far from the target pitch the
currently played note is. When only the center dot is lit, the note
is in tune.
Too low – tune up Too high – tune down In tune
REBEL CONTROL
13
EN