TC Electronic M5000, Руководство пользователя, Страница: 57 / 203

ALGORITHMS
M5ALGOIN
Rev 1.7 Page 35
signal level. Normally, you do not have
to change the factory default setting.
OUTLEV off - 0.0 dB. Sets the output level of the program in
0.5 dB steps. The function of this control
is to maximize dynamic range by
allowing the delay algorithm to output
maximum signal to the DA converters. It
affects the output PPM reading. Note
that there is a separate output level
control for adjusting the analog output
level. Set the
analog OUTLEV
adjustment in the G-LEVELS-menu
before setting this control. This control
does not affect the bypassed signal
level. Normally, you do not have to
change the factory default setting.
PAGE 2:
L-DELAY 1 - 670 mS (1.36 Sec.)
6
Sets the delay time for the left side.
R-DELAY 1 - 670 mS (1.36 Sec.)
1
Sets the delay time for the right side.
FB 0 - 99 % Sets common feedback level for left and
right delay output in percent. It feeds the
delay output for left and right separately
to its own input in order to make
repeatable stereo echo effects. The
control is common for left and right - but
the signals are processed individually.
PAGE 3:
FBLOCUT off - 800 Hz Common low cut filter control for left
and right feedback.
FBHICUT 1 KHz - off Common high cut filter control for left
and right feedback.
HICUT 500 Hz - flat High cut filter, shelving type. Provides
an overall high frequency rolloff (6 dB
per octave) that is well suited to make
the delay effect sound warmer Sets the
6
If high memory is installed (Idx=64K check your index memory under UTILITY menu CONFIG) max. delay
time is 1.36 Sec., otherwise max. delay time is 670 mS. (Idx=32K).