______________________________________________________________________________________________________________________________________________________________________________
__________________
TC Electronic A/S
Gold Channel Service manual
page 16
Software Changes
Software changes from 1.05 to 1.07:
1.
In mode "1->2 pre" the ch2 CLIP LED doesn't follow ch1's CLIP LED.
Corrected.
2.
Can't read preset cards from 1.02 and before. Corrected.
3.
"Number of presets to be copied" shows erroneous number (when
cardbank number to be copied is over cardbanksize). Corrected.
4.
V.1.03 and after can't recieve bulk dump of pre 1.03 userbank. Corrected.
5.
MIDI bulkdump speed reduction. Corrected.
6.
Changing input selection to DIGI shouldn't change from SYNC. Corrected.
7.
Sync, Dither, & Opt. Status should not be recalled in total recall.
Corrected.
8.
Midi Controller map for Gold Channel is implemented:
cc10 Input Channel 1 Mute , 0..63 Unmute, 64..127 Mute
cc11 Input Channel 2 Mute , 0..63 Unmute, 64..127 Mute
cc12 Input Channel 1 OutLevel, 0..127 Maps to -31dB to +6dB
cc13 Input Channel 2 OutLevel, 0..127 Maps to -31dB to +6dB
Above controllers are receive only, they are not send to MIDI out on the
Gold Channel.
Software changes from 1.04 to 1.05:
1.
Setup Win, Input Ch.2: ADAT channel shown when routing ch.1 to 2
fixed
2.
Reset Menu and User Info layout brush-up.
3.
Copy bank to/from card: Offset of 100 - fixed
Software changes from 1.03 to 1.04:
1.
POST Insert: Can't enter insert-edit-window - fixed
2.
EditPage: Unlinking with Enter sets channel 2 effect on. If it's done with the value dial
the effect returns to the state it had before it was linked - fixed
3.
Number of presets to be copied can become negative if no card is inserted - fixed
Software changes from 1.02 to 1.03:
1.
Different minor adjustments and bug -fixing in the user-interface displays.
2.
Four double cursor-positions in the Routing display (@ two channel/normal sample rate
mode) has been added, to enable inserting two blocks at a time. This is done to make it
possible to quickly set up a stereo routing.
3.
Softlim on/off parameter in Advanced EQ is renamed to Softclip on/off.
4.
Key sequence: Analo g gain change -> Menu left -> Exit, results in blank screen. Fixed
5.
Initial display contrast is not the same as present setting. Fixed
6.
After total recall the parameter "Proc. Delay" defaults to 1.1ms not the actual setting.
Fixed
7.
At the Signal page it is now possible to change the Status Bit output between AES/EBU
and S/PDIF.Place cursor at the output block, use Value wheel to change. When
AES/EBU is above S/PDIF in the output list, the Gold Channel output professional
status bits, and when S/PDIF is on t op of AES/EBU consumer status bits are output.
8.
Clicking when bypassing the EQ and Dynamic EQ has been fixed.
9.
Clicking when adjusting the EQ has been fixed.
10.
Clicking at PAD changes has been fixed.
11.
Software boot info screen now includes software version.
12.
At MIDI dumps some displays wasn't updated properly. Fixed
Содержание Gold Channel
Страница 1: ......
