TC Communications TC1910, Руководство пользователя

Страница: 17 / 24

- 17 -
TC1910
User's Manual
Rev. 2.0 (A0.3)
Master unit's IP address must be Static. The IP address should be entered at the "IP address" field on the
"LAN Setting" page.
Slave unit's IP address can be Static or Dynamic. For static IP setting, the IP address should be entered at
the "IP address" field on the "LAN Setting" page.
(Please refer to "LAN setting" section for more detail.)
For Slave unit dynamic IP setting, please refer to the "DHCP" section below.
DHCP (Dynamic Host Configuration Protocol) option is for Slave unit only. It enables the Slave unit to get
a temporary or permanent IP addresses (out of a pool) from a DHCP server.
In order to use the DHCP function, there should be a DHCP server residing at the user's local network. If
DHCP server is not available, the Slave unit's IP address must be Static. Please refer to the "Static IP"
section above for more information.
Before you turn on the DHCP option, you need to enter the Master’s IP address at the “Remote IP address”
field on the "LAN Setting" page for the Slave Unit.
Please do the following after the "Remote IP address" has been set on the Slave unit.
1. Power off the unit.
2. At the front panel, set "DHCP" DIP switch to on (down) position.
3. Power up the unit.
The “DHCP” LED will flash when the unit is obtaining an IP address from the DHCP server and the LED
turns solid after the unit gets one.