TBK-NVR2300 Network Video Recorder User Manual
106
⚫
Full Screen Monitoring Dwell Time:
Set the time in seconds to show the alarm event screen. If
alarms are triggered simultaneously in several channels, their full-screen images will be switched at
an interval of 10 seconds (default dwell time).
Go to the
Linkage Action
interface of the alarm detection (e.g., motion detection, video tampering,
face detection, etc.).
Select the
Full Screen Monitoring
alarm linkage action.
Select the channel(s) in
Trigger Channel
settings you for make full screen monitoring in Trigger
Channel Settings.
Auto-switch will terminate once the alarm stops and back to the live view interface.
Configure Audio Warning
The audio warning has the system to trigger an audible
beep
when an alarm is detected.
Go to
System
>
View
>
General
.
Enable the audio output and set the volume.
Go to the
Linkage Action
interface of the alarm detection (e.g., motion detection, video tampering,
face detection, etc.).
Select the
Audio Warning
alarm linkage action.
Notify Surveillance Center
The device can send an exception or alarm signal to the remote alarm host when an event occurs.
The alarm host refers to the PC installed with client software.
Go to
System
>
Network
>
Advanced
>
More Settings
.
Set the alarm host IP and alarm host port.
Go to the
Linkage Action
interface of the alarm detection (e.g., motion detection, video tampering,
face detection, etc.).
Select the
Notify Surveillance Center
.
Configure E-mail Linkage
The system can send an email with alarm information to a user or users when an alarm is detected.
Please refer to Chapter 15.7 Configure Email
for details of Email configuration.
Go to
System
>
Network
>
Advanced
.