Taylor 810 Series, Руководство оператора, Страница: 24 / 56

6-2
OPERATING PROCEDURES
Model 810, 812, 820, 822, 828 Series
Operating Procedures
6
4. Place the release sheet clips over the release sheet.
Press them into place over the release sheet bar at
the top of the platen.
Figure 6-4
5. Check the tightness of the release sheet against the
upper platen.
Figure 6-5
Note: Installing the release sheets too tightly may
cause premature failure of the sheet.
6. Repeat steps 1 through 5 for the remaining upper
platens.
Note: Temperature checks should only be
conducted with the release sheets removed.
The release sheet must be replaced when:
• Cleaning procedures fail to remove all buildup
and product sticks to the release sheet.
• A tear appears in the cooking area of the
release sheet, causing product to stick to the
release sheet.
Figure 6-6
Note: It is not necessary to change the release sheet if
small pin holes develop on the sheet.
CAUTION! The upper platen surface and
release sheet are very hot. To prevent burn injuries, wear
heat-resistant gloves when replacing the release sheets.
Release Sheet Care
• Do not fold or crease.
Figure 6-7
• Do not touch with sharp objects, grill scrapers,
or abrasive pads.
• Do not place under other equipment or objects.
• Do not hot-hose or soak in water.
• Clean with a squeegee after each run of
product.
• Wipe with a clean, sanitizer-soaked grill cloth a
minimum of four times per hour and more
often during peak periods.
• Clean daily on both sides, using an approved
high temperature grill cleaner and the grill
cleaning pad and holder identified on page 4-7.