The transmission range of the remote sensor is 200 feet. The effective transmission range is
vastly affected by obstacles such as walls, sheds, trees, etc. Try various setups for the best results.
Shorten the distance between the base and remote stations when necessary.
To get the most accurate readings and to prolong the life of your sensor, we recommend that
you mount it out of direct sunlight and rain. Direct sunlight will heat the casing and inflate
temperature readings. Place the sensor in a dry, shaded area. Fog and mist will not affect the
sensor, but large volumes of soaking rain may. To guard against this, we recommend that you
mount it under the eve of your house, your garage or any other suitable place that will keep it
out of direct sun and rain.
IMPORTANT:
Though the remote station is weather resistant, it should be placed away from
direct sunlight, rain, snow and should never be submerged in water.
TEMPERATURE READINGS
Press the “°F/°C” button on the back of the base station to switch between Fahrenheit and
Celsius temperature displays.
The base station displays the indoor temperature (“IN”) from its location. The remote station
transmits outdoor temperature (“OUT”) from its location back to the base station.
The indoor and outdoor temperature readings will display in either the large display window in
the center of the screen or the small window at the bottom left of the screen.
Press the “ ” button on the front of the thermometer to switch indoor/outdoor temperature
readings between the larger and smaller display windows. An “IN” or “OUT” icon next to the
temperature digits indicate which temperature location is displayed in the window.
CLOCK SETTING
The Clock display is located in the bottom right of the LCD screen.
1. Press and hold the “SET” button on the back of the base station for 3 seconds to enter
Clock Setting Mode.
“12 Hr.” or “24 Hr.” flashes in place of the clock digits.
2. Press the “+” button on the back of the base station to toggle between 12 or 24-hour
clock mode. Press “SET” to confirm. The hour digits’ flash.
3. Press the “+” button to change the hours. Press “SET” to confirm. The minute digits’ flash.
4. Press the “+” button to change the minutes. Press “SET” to confirm. The hour and
minute digits stop flashing. The clock is set.
NOTE:
If no buttons are pressed within 30 seconds, the station will automatically exit Clock
Setting mode.
