6
Model 161
Safety
130319
S
DO NOT
allow untrained personnel to operate
this machine.
S
DO NOT
put objects or fingers in door spout.
S
DO NOT
operate the freezer unless all service
panels and access doors are restrained with
screws.
S
DO NOT
remove the freezer door or beater
assembly unless the control switches are in
the “OFF” position.
Failure to follow these instructions may result in severe
personal injury from hazardous moving parts.
This unit has many sharp edges that can
cause severe injuries.
S
DO NOT
put objects or fingers in fill or
discharge openings. Failure to follow this
instruction may result in contaminated
product or personal injury from blade contact.
S
USE EXTREME CAUTION
when removing
the beater assembly. The scraper blades are
very sharp and may cause injury.
Access to the service area of the unit is
restricted to persons having knowledge and practical
experience with the appliance, in particular as far as
safety and hygiene are concerned.
This freezer must be placed on a level
surface. Failure to comply may result in personal injury
or equipment damage.
Cleaning and sanitizing schedules are
governed by your Federal, State, or local regulatory
agencies and must be followed accordingly. Please
refer to the cleaning section of this manual for the
proper procedure to clean this unit.
This machine is designed to maintain product
temperature under 41
_
F (5
_
C). Any product being
added to this machine must be below 41
_
F (5
_
C).
Failure to follow this instruction may result in health
hazards and poor freezer performance.
DO NOT
obstruct air intake and discharge openings:
A minimum of 6” (152 mm) on both sides, and 0” in the
rear is required. Install the skirt provided on the right
side of the unit. Failure to follow this instruction may
cause poor freezer performance and damage to the
machine.
This freezer is designed to operate indoors, under
normal
ambient
temperatures
of
70
_
- 75
_
F
(21
_
- 24
_
C). The freezer has successfully performed
in high ambient temperatures of 104
_
F (40
_
C) at
reduced capacity.
DO NOT
run the machine without product. Failure to
follow this instruction can result in damage to the
machine.
NOISE LEVEL:
Airborne noise emission does not
exceed 78 dB(A) when measured at a distance of 1.0
meter from the surface of the machine and at a height
of 1.6 meters from the floor.