4.
Input your gender.
The gender icons will be blinking.
Press (
!
)/(
"
) button to toggle between male and female icons.
Press (
MODE
) button to confirm all the settings with 1 long beep.
5.
Select Memory Location
- Press the (
!
)/(
"
) button to select desired memory
location (0-9). The memory number blinks.
Press “
MODE
” to store the settings
into the desired memory location. A “
beep
” sounds when the setting is
complete. An “ “ icon will be shown on the display.
NOTE
:
1. If the selected memory number is already occupied, a “ “ icon will display in
the lower right corner, under the memory number.
Your Personal Data is Now Stored into Memory.
Instructions For Use
Taking Your Body Fat and Weight Reading:
You must have bare feet to make this measurement
.
To receive the most consistent reading, use this scale at the same time of day under
the same conditions, ie, in the morning before breakfast without clothes as clothes
can vary in weight.
To Recall Settings from Memory:
1. Press and hold (
ON
) button for 2 seconds while the power is off. It will now enter
recall mode.
2. Press (
!
)/(
"
) button to toggle between memory locations (0-9).
3. If the selected memory number is unoccupied, no previous input will be displayed.
Battery Installation
1. Uses one 9-Volt alkaline battery (not included).
2. Remove Battery Compartment Cover on the bottom of the scale and insert
battery into the 9-Volt battery snap.
3. The scale needs to be initialized before first use or after battery replacement:
Press lightly on the scale platform. The display will show “
OOOO
”, then the scale
will automatically turn off. Your scale is now ready for use.
4. Replace the battery when “
Lo
” is displayed.
5. Remove the battery if the product is not used for a long time.
Getting Started
1. Select (lb/in) or (kg/cm) by the slide switch on the bottom of the scale.
Programming Personal Data into Memory
1.
Before stepping on scale.
Press (
ON
) button to enter BFA mode. The height figure
of the previous setting will be displayed on LCD. The height figure will be blinking.
2.
Input your height.
Press (
!
)/(
"
) button to increase /decrease the displayed height.
Press (
MODE
) button to confirm displayed height.
3.
Input your age.
The age figure of the previous setting will be displayed on LCD and
it will be blinking.
Press (
!
)/(
"
) button to increase /decrease the displayed age. Press (
MODE
) button to
confirm displayed age.
▲
MODE
MODE
▲
M
2
3
13477IB 10/13/04 12:13 PM Page 3
