Taylor 0738, Руководство оператора

Страница: 12 / 60

3
SAFETY
3-2 Model 0738 Safety
•
Stationary machine which are not equipped
with a power cord and a plug or another
device to disconnect the machine from the
power source must have an all-pole
disconnecting device with a contact gap of
at least 0.125 in. (3 mm) installed in the
external installation.
•
Machines that are permanently connected
to fixed wiring and for which leakage
currents may exceed 10 mA, particularly
when disconnected or not used for long
periods, or during initial installation, shall
have protective devices to protect against
the leakage of current, such as a GFI,
installed by the authorized personnel to the
local codes.
•
Supply cords used with this machine shall
be oil-resistant, sheathed flexible cable not
lighter than ordinary polychloroprene or
other equivalent synthetic elastomer-
sheathed cord (code designation 60245
IEC 57) installed with the proper cord
anchorage to relieve conductors from
strain, including twisting, at the terminals
and protect the insulation of the conductors
from abrasion.
•
If the supply cord is damaged, it must be
replaced by the manufacturer, service
agent, or a similarly qualified person, in
order to avoid a hazard.
Failure to follow these instructions may result in
electrocution. Contact your local Taylor distributor
for service.
CAUTION! This machine is designed
to maintain product temperature under
41°F (5
°
C). Any product being added
to this machine must be below 41
°
F (5
°
C). Failure
to follow this instruction may result in health
hazards and poor machine performance.
Do not obstruct air intake and discharge
openings: A minimum of 6 in. (152 mm) on both
sides, and 0 in. (0 mm) in the rear is required.
Install the skirt provided on the right side of the
unit. Failure to follow this instruction may cause
poor freezer performance and damage to the
machine. This freezer is designed to operate
indoors under normal ambient temperatures of
70
°
F to 75
°
F (21
°
C to 24
°
C). The freezer has
successfully performed in high ambient
temperatures of 104
°
F (40
°
C) at reduced capacity.
Do not run the machine without product. Failure to
follow this instruction can result in damage to the
machine.
Noise Level: Airborne noise emission does not
exceed 78 dB(A) when measured at a distance of
3.3 ft. (1.0 m) from the surface of the machine and
at a height of 5.25 ft. (1.6 m) from the floor.
Machine Warning Labels
General Safety
Rear Panel Warning Label
Do not operate the freezer without reading this
Operator’s Manual
This unit has many sharp edges that can cause
severe injuries.
Do not touch with hands, clean
with brush/vacuum cleaner.
Only authorized Taylor service personnel should
perform installation and repairs on this machine.
DANGER: High Voltage inside: danger of
electrocution. Disconnect the power supply
before servicing the machine.
CAUTION: Hazardous moving parts; the machine
can start automatically. Do not operate with
panels removed, disconnect the electrical supply
before servicing the machine.