Position one of the remaining brackets over the bottom end of the rear support
pole. Align the bracket to a position on the exterior of the transom. Mark the
location of the attachment holes on the bracket, using a pen or marker. Secure
the mounting bracket with two #10 x 3/4” screws and a Phillips screw driver.
Repeat this step for the opposite side rear support pole and connector.
Step 9:
Install Rear Supports:
Manually clamp two halves of one rear support pole connector,
around one frame support pole at the transom area as in the
picture below. Note the pole sets into the vertical channels in
the connector. Place three of the #10 screws thru the con-
nector and loosely attach the lock nuts - enough to keep the
connector in place but not fully tightened. Insert a rear support
pole into the angled opening on the connector - be sure that it
is fully inserted. Position the bracket on the frame and orient
the support pole towards the transom of the boat. Tighten the
screws on the connector to secure in place.
The assembly of your Inflatable Boat Quick Shade is now complete.
To remove the Top for storage or when your boat is underway, simply follow
these easy steps:
TAYLOR MAKES NO EXPRESS OR IMPLIED WARRANTIES OTHER THAN WARRANTIES SET FORTH HEREIN, INCLUDING, WITHOUT LIMI-
TATION, THE WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR FROM ANY COURSE OF DEALING OR
TRADE USAGE.
TAYLOR SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT, INCIDENTAL, PUNITIVE OR CONSEQUENTIAL DAMAGES, INCLUDING, WITH-
OUT LIMITATION, DAMAGES FOR LOSS OF OPPORTUNITY OR BUSINESS PROFITS, BUSINESS INTERRUPTION OR ANY OTHER LOSS
EVEN IF TAYLOR HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
IN NO EVENT SHALL TAYLOR BE LIABLE FOR ANY AMOUNT IN EXCESS OF THE PURCHASE PRICE PAID.
ADDITIONAL WARRANTY INFORMATION
Taylor Made Products
65 Harrison Street
Gloversville, NY 12078
A Member of The Taylor Made Group
www.taylormadeproducts.com
®Taylor Made is a registered trademark of the Nelson A. Taylor Co., Inc.
© 2007 Nelson A. Taylor Co., Inc.
• Unhook the 4 remaining cords at each corner of the top from the mounting brackets.
• Release the Hook & Loop fasteners from around the poles and remove the Top, fold up and place aside (for long term
storage - never pack up a wet or damp Top).
• Remove the Center (3 section) pole from the frame of the Top - disassemble and fold up pole sections.
• Remove both of the rear support poles from the connectors at the transom.
• Gently pull one end of one pole from the mounting bracket - Gently allow the pole to straighten out. BE VERY
CAREFUL AS YOU MANUVER THE POLE - IT WILL FLEX BACK STRAIGHT VERY QUICKLY IF NOT
HELD SECURLY. Disassemble and fold up the pole sections. Repeat for the second 7 Section pole.
• A convenient storage bag has been provided for your Quick Shade.
