Taylor-Dunn TT-416, Руководство оператора

Страница: 20 / 56

Page 20 TT-416 Stand Up Tow Tractor
MT-416-00
Interlocks
Operator Presence: OPS: A switch located
under the operator platform disables the power
to the vehicle when the driver exit the vehicle.
The driver must be in the approved operator
position for the vehicle to operate.
Whenever the driver leaves the vehicle, the
driver should turn the key-switch “OFF”, place
the forward-off-reverse switch in the center
“OFF” position.
Battery Door: Two switches located on the left
and right to the rear of the battery compartment
disables power to the vehicle whenever the
battery doors are removed or not properly
installed.
Parking Brake
This vehicle is equipped with an automatically
actuated electromagnetic parking brake.
During normal operation, the parking brake will
be applied when the treadle is released and the
motor comes to a stop. The brake will release
again when the treadle is pressed for travel.
Unless in an emergency, do not turn the start
switch OFF while the vehicle is in motion.
Turning the start switch OFF will immediately
apply the parking brake, stopping the vehicle and
result in accelerated wear of the brake.
Some motor control system faults will result
in parking brake application or failure of the
brake to release. Should this occur, there is a
brake bypass switch that will release the brake
and allow the vehicle to be moved. For more
information, Refer to Towing This Vehicle later
in this manual.
The brake bypass switch will not function if the
batteries are disconnected or there is a failure
in the vehicle power supply. Should this occur
and the vehicle must be moved then the drive
wheels must be placed on a towing dolly or the
brake removed from the motor.
The park brake should be disabled for
servicing or towing procedures only. Do
not operate the vehicle while the automatic
park brake is disabled. Operating the
vehicle with the automatic park brake
disabled could lead to severe bodily injury
and/or property damage.
WARNING