Taylor-Dunn Tiger TC50E, Руководство оператора

Страница: 20 / 58

Page 20
C0-T50-80 Owners Manual
MC-TC50E-01
Windshield Wiper
#9: Optional. The wiper has a 2-speed wiper
motor. The wiper is off when the switch is in the
lowest position (push on bottom of actuator).
Normal speed is when the switch is in the 2nd
position (push top of actuator 1-click from off).
Fast speed is when the switch is in the 3rd
position (push top of actuator 2-clicks from off).
High Beams (headlight)
#10: A push button latching switch is located on
the end of the directional switch lever. Depress
and release to turn the high beams on or off.
4-Way flashers
#11:
The actuator lever for the 4-way flasher is
located behind the directional switch lever. Pull
the actuator out to turn the 4-way flashers on. To
turn the 4-way flashers off, move the directional
switch lever in either direction.
Directional Signal Switch
#12: Use the directional switch lever to indicate
a left or right Turn. Push the lever away
(clockwise) to signal a right turn. Pull the lever
closer (counterclockwise) to signal a left turn.
The directional switch does not automatically
reset. Move the lever to the center off position
after completing a turn.
Interlocks
Operator Presence: A switch located under the
driver’s seat disables the power to the vehicle
when the driver leaves the seat. The driver must
be seated for the vehicle to operate.
Whenever the driver leaves the vehicle, the
driver should turn the key-switch “OFF”, place
the Shift Lever in the center “OFF” position.
Foot Brake: This vehicle is equipped with a foot
brake interlock. The vehicle control system will
not run if the foot brake is applied.
Parking Brake: This vehicle is equipped with
a parking brake interlock. The vehicle control
system will not run if the parking brake is applied.
Rear Charger Connector: A switch located on
the charger connector disables power to the
vehicle whenever a charger is connected.
Shift lever
Do not dismount the operator’s seat while
the vehicle is in motion. Getting off of the
seat will activate the Operator Presence
circuit, rapidly slowing the vehicle and
applying the park brake. The abrupt
slowing of the vehicle may result in severe
bodily injury.
The operator presence switch is only
one part of the vehicle safety system.
It should not be relied upon as the
only safety feature used to disable or
disengage this vehicle. Doing so could
result in unexpected movement of the
vehicle causing severe bodily injury and/
or property damage.
WARNING
The shift lever has 4-positions.
H (high) : Move the shift lever to the right and
then up to the second notch in the index plate.
High will allow the vehicle to obtain it’s maximum
speed but will also reduce the running time due
to increased demand from the battery.
L (low) : Move the shift lever to the right and
then up to the first notch in the index plate. Low
should be used while pulling loads greater then
half of the vehicle capacity or pulling any load
up or down a grade.
Off : The lever is shown in the Off position in
the illustration.
Reverse : From the Off position, move the shift
lever to the right and then back.