Taylor-Dunn SC 0-90, Руководство по эксплуатации, устранению неисправностей и замене запасных частей

Страница: 30 / 130

Maintenance, Service, and Repair
Front Axle
Page 2
INSPECT THE FRONT WHEEL BEARINGS
6. Raise the front of the vehicle and support with jack stands.
7. Grab the top and bottom of the tire/wheel assembly.
Feel for any movement or play while pulling and
pushing on the top and bottom of the tire. Any
movement or play is indication of loose wheel
bearings or king pin.
8. Spin the front wheel(s) by hand. The wheel should
stop spinning in no more than 2-revolutions. A wheel
that continues to spin freely is an indication of a
loose wheel bearing.
Note: Refer to the
Adjust Front Wheel
Bearings
section for information regarding
the adjustment of the wheel bearings.
9. Spin the wheel(s) and listen for any grinding noise.
Any noise may be an indication of worn or damaged
wheel bearings.
Note: Refer to the
Replace Front Wheel
Bearings
section for information regarding
the replacement of the wheel bearings.
10. Lower the vehicle.
11. Reconnect the main positive and negative cables at the batteries.
12. Remove the blocks from behind the wheels.
13. Release the park brake and test drive the vehicle.
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.