Taylor-Dunn BurdenMaster B 2-00, Руководство по эксплуатации, устранению неисправностей и замене запасных частей

Страница: 134 / 266

Maintenance, Service, and Repair
Transmission Page 2
CHECK OIL LEVEL
Park the vehicle on a level surface.
6. Place a drain pan that can hold a minimum of
2-quarts of oil under the transmission level plug.
7. Remove the level plug. When the plug is removed,
a small amount of oil should come out. This
indicates that the transmission has the correct
amount of oil.
8. If no oil comes out, then lift the side of the vehicle
with the level plug and add 11-ounces of oil through
the level plug hole. See the illustration below.
9. Lower the vehicle, allow any excess oil to drain into the drain pan, and then reinstall the level
plug.
10. Reconnect the main positive and negative cables at the batteries.
11. Remove blocks from behind the wheels.
12. Test drive the vehicle
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Level Plug viewed from in front of
the right rear wheel
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.