Taylor-Dunn B0-T48-48 Taylor Truck T48, Руководство по эксплуатации

Страница: 94 / 240

SECTION 3 PAGE 58
MB-T48-01
15. Remove the nuts from the A1 and A2 terminals
and the brush holder retaining screws, then remove
the brush holder assembly from the commutator end
cap.
NOTE: Be sure to remember
the position of the cross over
wires.
16 . Repair or replace
components as necessary.
NOTE: When press
ing the new bearing
on to the armature
shaft, be sure to press
on the inner race
of the bearing.
17. Reassemble the motor, be sure to use a
new bearing.
18. Pull the brushes out from the brush
holder until the spring holds the brush
from sliding forward. When the motor
has been reassembled push the brushes
against the commutator, making sure
the spring is not in contact with the
brush wires.
19. Using the appropriate procedure install
the motor and reconnect the wires.
20. Reconnect the main positive and negative
cables at the batteries.
21. Remove the blocks from behind the wheels.
22. Release the park brake and test drive the vehicle.
M o t o r
Bearing
Inner
Race
Only Press on the Inner
Race of the Bearing
Installing Motor
Bearing
Brush Spring Incorrect
Position
The brushes must be positioned away
from the commutator as it is pressed
into position. Failure to do so may cause
damage to the motor.
Brush Spring Correct
Position