5. Before starting the equipment
Be sure to read the following information
before you use your cordless screwdriver for
the first time:
1. Charge the battery pack with the charger
supplied.
2. Only ever use screwdriver bits which are
suitable for the purpose and in faultless
condition.
3. Always check for concealed electric cables
and gas and water pipes when drilling and
screwing in walls.
6. Operation
6.1 Charging the battery (Fig. 1)
The battery is protected from exhaustive
discharge. An integrated protective circuit
automatically switches off the equipment when
the battery is flat. In this case the bit chuck will
cease to turn.
Warning!
Do not press the ON/OFF switch any
more if the protective circuit has actuated. This
may damage the battery.
1. Check that your mains voltage is the same
as that marked on the rating plate of the
battery charger. Plug the battery charger in
the plug socket and connect the charging
cable to the charging connection. The
charging process starts as soon as the
charging cable is connected to the charging
adapter.
2. The red LED (7) will come on to indicate
that the battery pack is being charged.
3. The charging control lamp (7) goes out
when charging is completed.
Important! The handle may become a little
warm during the charging process. This is
normal.
If the battery pack fails to charge, please check
whether there is voltage at the socket-outlet
and check for proper contact with the
charging contacts in the battery charger.
If the battery still fails to charge, send
the battery charger
and the screwdriver
to our customer services department.
Timely recharging of the battery pack will help
it serve you well for a long time. You must
recharge the battery pack when you notice that
the power of the screwdriver drops.
6.2 Changeover switch (Fig. 2/Item 10)
The slide switch above the ON/OFF switch is
for setting the direction of rotation of the
cordless screwdriver and for preventing the
cordless screwdriver from being switched on
inadvertently. You can select between
clockwise and counter-clockwise rotation.
Change the direction of rotation only when the
equipment is at a standstill. If you fail to
observe this point, the gearing may become
damaged. When the slide switch is in the
middle position, the ON/OFF switch is blocked.
6.3 ON/OFF switch (Fig. 2 / Item 9)
Press the On/Off switch to switch the cordless
screwdriver on. Release the ON/OFF switch to
switch off the tool.
6.4 LED lamp (Fig. 3/Item 2)
The LED lamp (2) can be used in poor lighting
conditions to illuminate the area where you
want to screw.
To switch on, push the switch (4) forwards; to
switch off, pull the switch back again.
6.5 Magnetic screw holder (Fig. 3/Item 3)
Screws can be placed on the magnetic screw
holder for easy reach during operation.
6.6 Battery capacity indicator (Fig. 4/Item 5)
Press the button for the battery capacity
indicator (6). The battery capacity indicator (5)
indicates the charge state of the battery on 3
colored LEDs.
All LEDs illuminate:
The battery is fully charged.
After Sales Support TEL: 1300 130 579 WEB: www.rossmac.com
10
Anleitung_RT_SD_3_6_Li_SPK7_GB:_ 30.07.2009 11:22 Uhr Seite 10
