- 11 -
Panel:
1
Push-button - Welding Material
：
Select between AlSi, AlMg, CrNi, Fe, Cu
or SP and the selected material light will be turned on
.
2
Save-button
：
Saves the completed welding parameters
.
3
Memory-button
：
Ten sets (0 - 9) of adjusted welding parameters can be
recalled and saved during each operation
.
4
Wire-feed-button:
Press and hold the feed button to start the wire feed.
Releasing the button will stop the wire feed
.
5
Gas
：
Press and hold the gas button to start the gas flow inspection.
Releasing the button will stop the gas flow
.
6
Resume-button:
After holding this button depressed for 3 seconds, all
parameters will be restored to factory values
.
7
Voltage-adjusting Dial:
Turning the dial will adjust the voltage output
.
8
Push-button - Left Menu:
Tapping this button will allow setting voltage, arc
voltage and induction when the corresponding light is lit
.
9
Push-button - Right Menu:
Tapping this button will allow setting current,
wire-feed speed, thickness and time when the corresponding light is lit
.
10
Current-adjustment dial:
Turn the dial to adjust the current output.
.
11
Push-button - Select from parameters
：
Tapping this button will allow
setting values of pre-flow, ignition current, up slope, down slope, finish
current and post-flow when the corresponding light is lit
.
4
12
1
2
7
8
9
10
3
5
6
11
13
14
15
