Taurus ICONIC DIGITAL ADVANCE, Руководство пользователя

Страница: 10 / 64

-If only one pilot light lights up this means that
the battery has very little power remaining.
-If no pilot light lights up, this means that the
battery is completely flat.
-NB: For a long battery life, it is advisable to
charge the battery, only, when it has run out
completely.
ASSEMBLING THE BATTERY/S
-Caution: During the handling of batteries, do
not touch both poles at the same time, as this
will provoke the partial discharge of the stocked
energy therefore affecting longevity.
-Put the battery in its compartment, respecting
the polarity.
INSTRUCTIONS FOR USE
BEFORE USE:
-Make sure that product’s packaging has been
removed.
-Before using this product for the first time, it is
important to make a full charge of batteries.
-Prepare the appliance according to the function
you wish to use:
VACUUMING FUNCTION:
USE:
-Turn the appliance on, by using the on/off
button.
-Select the desired speed by pressing the
speed selector button (N), pressing once and
twice according to the speed required at any
time. (Fig.2)
FITTING AN ACCESSORY TO THE HAND
VACUUM:
-The hand vacuum is designed in such a way
that it allows the following accessories to be
fitted: (use the combination that best meets
your requirements). (Fig.3)
-Furniture brush: Equipped with a brush at the
end, which brushes the surface as it is used.
-Crevice nozzle: Specially designed for getting
into cracks and difficult corners.
explosion or fire hazard when used with other
battery/ies.
-Use the device only with the battery/ies for
which has been specifically designed. The use
of any other battery/ies s can cause an explo-
sion or fire hazard.
INSTALLATION
-Be sure to remove all packaging material from
inside the appliance.
ASSEMBLING THE WALL BRACKET:
-The appliance has a wall bracket (K) which
must be fixed to the wall.
-Fix the wall bracket as you think appropriate,
using plugs, screws, and adhesive…
-Place the support by matching the holes with
the rawlplugs and screw in firmly.
-Make sure that the bracket is firmly fixed; it
should be able to support twice the weight of
the appliance.
-Fit the appliance into the wall support.
CHARGING THE BATTERY
-Caution: A new battery is not fully charged and
must therefore be charged before the applian-
ce is used for the first time.
-Charge the battery at an atmospheric tempera-
ture of between 4 and 40ºC.
-Plug the charger into the mains.
-A pilot light will come on to indicate that the
charger is ready to begin charging the battery.
-Approximately 4 to 5 hours are needed for a
complete charge of the battery. Never attempt
to over-charge the battery (although it is re-
commended that the first charge of the battery
be of 6 hours in duration).
-Plug the charger of the vacuum cleaner (L)
into the battery charging connector (M) of the
appliance, located on the back of the applian-
ce, under the battery. (Fig.1)
-NB: Do not use the appliance while it is con-
nected to the charger.
HOW TO CHECK THE BATTERY’S CHARGE
LEVEL:
-Start the appliance by pressing the start / stop
button. (G)
-If all five lights (F) light up it means a full char-
ge level.