Taurus GI4EB, Руководство пользователя

Страница: 20 / 84

INSTALLING PROCESS:

Remove the pan supports, the burner lid and flame
spreader and carefully turn the appliance upside
down and place it on a cushioned mat.

Take care that the ignition devices and flame
supervision devices are not damaged in this
operation.

Apply the sponge provided around the edge of the
appliance. The thickness of the sponge is 3 mm and
the width is 10 mm.

Do not leave a gap in the sealing agent or overlap
the thickness.

Do not use a silicone sealant to seal the appliance
against the aperture. This will ae it difficult to remove
from the aperture in future, particularly if needs to be
serviced.

Place the bracket (B) over the holes that match the
size of the screw. There are one set of screws holes
in each corner of the hob. Slightly tighten a screw
(C) through the bracket (B) so that the bracket is
attached to the hob, but so that you can still adjust
the position.

Carefully turn the hob back over and then gently
lower it into the aperture hole that you have cut out.

On the underneath of the hob, adjust the brackets
into a position that is suitable for your worktop. Then
fully tighten the screws (C) to secure the hob into
position.
GAS CONNECTION:

This appliance must be installed and connected in accordance with installation regulations
in force in the country in which the appliance is to be used.

This appliance is supplied to run on LPG.

It is the law that all gas appliances are installed by competent persons in accordance with
the current edition of Gas Safety Installation and Use Regulations.

It is in your interest and that of safety to ensure compliance with the law.
GAS SPECIFICATION
GAS TYPE AND PRESSURE HEAT INPUT AND ORIFICE SIZE MARKED (MM)
Wok burner Rapid burner Semi-rapid Auxiliary - rapid
/ 3,0Kw
(218g/h)
1,75 kW
(127 g/h)
1,0 kW
(73 g/h)
G30 29 mbar / 0,87 0,66 0,50