Taurus CG4HN/B, Инструкция по эксплуатации

Страница: 20 / 88

INSTALLING PROCESS:

Remove the pan supports, the
burner lid and flame spreader and
carefully turn the appliance upside
down and place it on a cushioned
mat.

Take care that the ignition devices
and flame supervision devices are
not damaged in this operation.

Apply the sponge provided around
the edge of the appliance. The
thickness of the sponge is 3 mm
and the width is 10 mm.

Do not leave a gap in the sealing
agent or overlap the thickness.

Do not use a silicone sealant to
seal the appliance against the
aperture. This will ae it difficult to
remove from the aperture in future,
particularly if needs to be serviced.

Place the bracket (B) over the holes
that match the size of the screw.
There are one set of screws holes
in each corner of the hob. Slightly
tighten a screw (C) through the
bracket (B) so that the bracket is
attached to the hob, but so that you
can still adjust the position.

Carefully turn the hob back over
and then gently lower it into the
aperture hole that you have cut out.

On the underneath of the hob,
adjust the brackets into a position
that is suitable for your worktop.
Then fully tighten the screws (C) to
secure the hob into position.
GAS CONNECTION:

This appliance must be installed and connected in accordance with installation regulations
in force in the country in which the appliance is to be used.

This appliance is supplied to run on LPG and natural gas. Conversion for use on LPG and
natural gas must only be undertaken by a qualified person.