Taurus ALPATEC AC 280, Руководство пользователя, Страница: 21 / 32

English
Water tank full protection:
- When the water level in the bottom water plate
is above the warning level, the unit will alert
automatically a.
-Please discharge water in the machine according
to chapter “water drainage”.
Water drainage:
- When the inner water tank is full, its indicator will
flash on the screen.
- The appliance enters into standby mode.
- Pull out the plug to drain out water, power off
the machine and restart it , the machine will runs
normally.
-This model have self evaporative function,
under cooling mode, please do not use continue
drainage to get better cooling effect.
Once you have finished using the appliance:
- Turn the appliance off, using the on/off switch.
- Unplug the appliance from the mains.
Cleaning
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the electrical equipment and the mains
connection with a damp cloth and dry. DO NOT
IMMERSE IN WATER OR ANY OTHER LIQUID.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products, for
cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- If the appliance is not in good condition of
cleanliness, its surface may degrade and
inexorably affect the duration of the appliance’s
useful life and could become unsafe to use.
Air filter cleaning:
- Clean the air filters every 2 weeks. If the air filter
is blocked with dust, the efficiency will reduce.
- Pull out up and down filter as below pictures
- Wash the air filters by immersing it gently into
warm water with a neutral detergent, rinse it and
dry it thoroughly in a shaded place.
- Install air filters carefully after cleaning the filters.
After Season Maintenance:
- Pull out the plug in drainage hole and empty the
water received plate, or drain out the water by
leaning the unit, then shift the unit mode to Fan
mode, and press the button till it low fan speed.
-Keep this mode for half day till the conduit is
dried. Doing like this can keep the inner unit dried
and not go mouldy.
- Turn off the unit and pull out the plug.
- Coil the wire and bind it together, then put it into
the accessories room.
- Separate the air-exhausted pipe and safely
keep it.
- Put the unit into a plastic bag, and then keep it
in a dried place.
- Take out the batteries of remote control and
safely keep them.
Anomalies and repair
- Take the appliance to an authorised technical
support service if product is damaged or other pro-
blems arise.
Do not attempt to disassemble or repair the
appliance yourself as this may be dangerous.
- If any anomaly is detected, check the following
table: