IR CAB Simulation
If you want to record your guitar or use the amplifier as a pre-amp without a cabinet then you
have a special tool on board - an advanced loudspeaker simulator with IR louder. It is possible
to save 16 IR files of speaker simulation through the USB port.
A simulation of the microphone position is also available and provides additional possibilities of
equalizing the colour of your sound at the line output. Thanks to this solution you can get closer
to the sound conditions of a classic set of speakers with a microphone setup.You get the right
placement and sound of the instrument in the band's mix by transmitting the signal from the
line output without using the speaker. All this is done in an analog way, very simple and
intuitive, without the use other additional processors. The line output has two signals paths,
with or without simulation. This feature also allows you to connect an external loudspeaker
simulator. So you can use the built-in simulation, external simulation or both of them at once.
How to transfer IR files.
1. Download and install the IR converter on your computer.
The program allows you to convert files of various formats to the IR Sh7 format.
2. Download and install the file for editing and saving files.
The program allows you to save and transfer files to the amplifier as well as edit the sound
or create your own speaker profiles to define the sound on line output.
CAB SIM has 16 factory profiles that can be edited or loaded your own.
To load your own files, first convert them in the file converter installed on your computer as
follows:
1. Start the IR converter program
2. Click "select source IR files" and select the files to convert.
3. Click "select destination folder" and select a folder to save files in the new format
4. Make the conversion by clicking on "Start conversion".
To load the prepared pulses, connect the SH7 to the computer with the MINI-USB / USB cable
without turning on the amplifier's power.
Then the SH7 loader will be visible on computer screen as an external drive to which the
previously prepared IR files should be transferred.
The memory bank architecture is set as follows: there are four banks (0,1,2,3).
Each of them may contain four files marked on the selector (0,1,2,3).
After loading the files, turn on the amplifier. Then start to use the loaded files by choose them
with the selector located on the back panel.
Each of the files can also be edited and saved using the IR pulse editing program: AMT
Pangea CP PA. The timbre of the sound can be easily adjusted live with the MIC POSITION
knob.
Download files with software from the website: www.taurusamps.pl/sh7-download
Fuse: 2.5A
Fuse: 2.5A
(PA-INPUT)
SEND
RETURN
EFX
LO HI
CABINET
RESONANCE
SERIAL NO:
MADE IN
EU
CAUTION!
SPEAKERS
4-8-16ohm
Fuse: 2.5A
THIS APPARATUS
MUST BE EARTHED
Power Stage Efficiency:
200Watt
RISK OF ELECTRIC SHOCK,
DO NOT OPEN.
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS PRODUCTS TO RAIN OR MOISTURE
GAIN
EXT.CTRL.
CABINETS
Two mode output
DRY
SIMULATION
LINE OUT
MIC
POSITION
IR-CAB
loader
0
1
2
3
0
1
2
3
1
2
2
3
3
0 1
3
0
1
2
0
Pangaea CAB SIM
designed by
AMT
MICROPHONE POSITION
USB for files transfer
16-position CAB SIM selector
