14
D705M
CONTROL PANEL FOR 230 Vac SINGLE-PHASE MOTOR
• MICROPROCESSOR-CONTROLLED LOGIC
• INPUT STATUS LED’S
• LINE INPUT FUSE
• BUILT-IN FLASHING LIGHT CIRCUIT
• “MAN PRESENT” FUNCTION
• ELECTRIC BRAKING
• WEEKLY TIMER INPUT
•
MOTOR TORQUE CONTROL AND OBSTACLE DETECTION BY MEANS OF ENCODER
• 433.92 MHz 2 CHANNEL BUILT-IN RADIO RECEIVER (CH)
•
CONTROL OF THE SENSITIVE EDGE
ATTENTION:
-
do not use single cables (with one single wire), ex. telephone cables, in order to
avoid breakdowns of the line and false contacts.
-
do not re-use old pre-existing cables.
TESTING
When all connections have been made:
• All the green LS LED’s must be on (each corresponds to a Normally Closed input).
• They only turn off when the commands they are associated with are active.
• All the red LS LED’s must be off (each corresponds to a Normally Open input) they only turn
on when the commands they are associated with are active.
TECHNICAL CHARACTERISTICS
Power input to board
230V AC - 50÷60Hz
Nominal power
600 W ca.
Primary input line rapid fuse (F1 - 5x20)
F3,15A - 250V AC
Input voltage of motor circuits
230V AC
Input voltage of auxiliary circuits
24V AC
24Vac line rapid fuse (F2 - 5x20)
F1,6A - 250V AC
Logic circuit input voltage
5V DC
Working temperature
-20°C ÷ + 55 °C
Box protected to
IP43
DIAGNOSTICS LED
DL1 (STOP)
STOP button green LED signal
DL2 (PEDESTRIAN)
PEDESTRIAN button red LED signal
DL3 (STEP BY STEP)
STEP BY STEP button red LED signal
DL4 (OPEN)
OPEN button red LED signal
DL5 (CLOSE)
CLOSE button red LED signal
DL6 (SENSITIVE EDGE)
SENSITIVE EDGE green LED signal
DL7 (PHOTOCELL)
PHOTOCELL green LED signal
DL8 (CLOSE LIMIT SWITCH)
CLOSE LIMIT SWITCH green LED signal
DL9 (OPEN LIMIT SWITCH)
OPEN LIMIT SWITCH green LED signal
DL10 (RADIO CONTROLS)
RADIO CONTROLS programming red led
ENGLISH
