8
Remote Control
Installing battery
Remove the battery cover, and insert two AAA (1.5V) batteries; make sure that the polarity of the battery is
consistent with the marks "+/-" in the battery slot.
Precautions of remote control usage
Point the remote control to the receiver window. The objects between remote control and the receiver
window may disturb the normal operation.
Keep the remote control away from strong vibration. In addition, do not set or put the remote control in
direct sunshine, which may result in deformation of the remote control.
The remote control may be invalid if the receiver window is in direct sunshine or strong light; in this case,
please adjust the angle of the light or the device, or approach the remote control to the receiver window.
The effective range of the remote control may be affected if the battery voltage is low; in this case, please
replace with a new battery; if the remote control won't be used or battery voltage is too low, please take out
the battery to avoid corrosion due to battery liquid leakage.
Do not mix different types of batteries, or used and new batteries.
Do not throw the batteries into fire, charge or break up, or charge, short circuit, disassemble, heat or burn
the used batteries. Please follow the environmental protection regulations to disposal of the batteries.
●
●
●
●
●
●
Turning on/Standby
Insert the power plug into the outlet. Press " " button on the
set, and press " " key on the remote
control or on the control panel to turn on the
set. Press " " key again to switch the
set to
standby state.
★
Special note
This device adopts energy saving technology:
1. If there is no signal input in power on state, the
set enters standby state automatically after five
minutes.
2. When the schedule power off time is reached, the
set enters standby state automatically.
Signal source selection
Press ''
SOURCE
'' key either on the remote control or on the control panel. The menu of
''Input Source'' will be displayed on the screen. Then press "
▲
/
▼
" key on remote control
or "
UP
/
DOWN
" key on the control panel to choose the signal source. Press ''
OK
'' key on the
remote control or ''
MENU
" key on the control panel and
will switch the current signal
source to the signal source you choose.
Menu operation description
Press '
'MENU
'' key on the remote control or on the control panel,
then the
will display the main menu.
1. Press "
/
" key on the remote control or ''
VOL+
/
VOL-
'' key on
the control panel to select the adjustment sort menu, which
includes 3 sorts: PICTURE, SOUND, OSD.
2. Press "
▼
" key on the remote control or ''
DOWN
'' key on the control
panel to enter the adjustment sort menu.
3. Press "
▲
/
▼
" key on the remote control or ''
UP
/
DOWN
'' key on the
control panel to select what is needed to adjust in sort menu.
"
/
"
Monitor
Monitor
Monitor
Monitor
Monitor
Monitor
Monitor
4. Press
key on the remote control or ''
VOL+
/
VOL-
'' key on
Input Source
AV1
AV2
YPbPr
PC
HDMI1
HDMI2
USB1
USB2
Adjust
Select
Menu:Exit
Full
Standard
48
48
50
55
50
Picture Mode
Contrast
Brightness
Saturation
Sharpness
Aspect Ratio
Color Temp.
Noise Reduction
Hue
Soft
Off
Basic Operations