EN
6
2
Things to be done for energy saving
• Do not leave the doors of your refrigerator
open for a long time.
• Do not put hot food or drinks in your
refrigerator.
• Do not overload your refrigerator so that
the air circulation inside of
it is not prevented.
• Do not install your refrigerator under
direct sunlight or near heat emitting
appliances such as ovens, dishwashers
or radiators. Keep your refrigerator at least
30cm away from heat emitting sources
and at least 5cm from electrical ovens.
• Pay attention to keep your food in closed
containers.
• For products with a freezer compartment;
You can store maximum amount of food
items in the freezer when you remove the
shelf or drawer of the freezer. Energy
consumption value stated for your
refrigerator has been determined by
removing freezer shelf or drawer and
under maximum load. There is no harm to
use a shelf or drawer according to the
shapes and size of food to be frozen.
• Thawing frozen food in fridge
compartment will both provide energy
saving and preserve the food quality.
In case the information which are
given in the user manual are not
taken into account, manufacturer
will not assume any liability for this.
Important:
The connection must be in compliance
with national regulations.
• The power plug must be easily accessible
after installation.
• Electrical safety of your refrigerator shall
be guaranteed only if the earth system in
your house complies with standards.
Points to be paid attention to when the
relocation of the refrigerator
1. Your refrigerator should be unplugged.
Before transportation of your refrigerator,
it should be emptied and cleaned.
2. Before it is re-packaged, shelves,
accessories, crisper, etc. inside your
tape and secured against impacts.
Package should be bound with a thick
tape or sound ropes and the
transportation rules on the package
should be strictly observed.
3. Original packaging and foam materials
should be kept for future transportations
or moving.
Before you start the refrigerator,
Check the following before you start to
use your refrigerator:
1. Clean the interior of the refrigerator as
recommended in the “Maintenance and
cleaning” section.
2. Connect the plug of the refrigerator to
the wall socket. When the fridge door is
opened, fridge internal lamp will turn on.
3. When the compressor starts to operate,
a sound will be heard. The liquid and
gases sealed within the refrigeration
system may also give rise to noise, even
if the compressor is not running and this
is quite normal.
4. Front edges and both sides of the
refrigerator may feel warm. This is normal.
These areas are designed to be warm to
avoid condensation.
Electrical connection
Connect your product to a grounded
socket which is being protected by a fuse
with the appropriate capacity.
Installation
3
