TATA Motors Safari 2.2 VTT Dicor, Руководство пользователя

Страница: 118 / 172

108
Changing of Engine Oil and Oil Filter
Change the oil and oil filter at specified service intervals. (Engine oil and
oil filter may be changed earlier inline with recommendation given for
additional maintenance schedule under severe driving condition)
Changing of oil and oil filter requires access from underneath the vehicle.
Vehicle should be raised on a hydraulic lift of a service station or should
be on a service pit.
1. Run the engine until it reaches normal operating temperature. Then
shut it off.
2. Remove oil sump guard.
3. Open the bonnet and remove engine oil filler cap. Remove the drain
plug of the oil sump from the bottom of the engine. Drain the oil into
an appropriate container.
4. Remove the oil filter with the help of special wrench. The removed
oil filter should not be reused and hence should be destroyed to
avoid recycling of the same. Used filter and oil should be disposed
in compliance with the current legislation.
5. Ensure cooler is tightened to it’s position.
6. Smear a little fresh engine oil on rubber gasket of new engine oil
filter. Hand tighten the engine oil filter fully and further 3/4 turn with
special tool.
Do not over tighten engine oil filter as this may damage oil filter and
oil may leak out.
7. Before filling in fresh oil in the engine, clean the drain plug.
ENGINE OIL & OIL FILTER
1. Engine Oil Filling Neck
2. Dip Stick
1. Oil Sump Drain Plug
2. Engine Oil Filter
M A I N T E N A N C E
2
1