TATA Motors Olive VME101, Руководство пользователя

Страница: 16 / 29

16
$sudo modprobe usbserial vendor=0x201e product=0x2009
After that, using the command “dmesg” to check again, it will see the following information:
usbcore: registered new interface driver usbserial
drivers/usb/serial/isb-serial.c: USB Serial support registered for generic
usbserial_generic 2-2:1.0 generic converter detected
usb 2-2: generic converter now attached to ttyUSB0
usbserial_generic 2-2:1.1 generic converter detected
usb 2-2: generic converter now attached to ttyUSB1
usbserial_generic 2-2:1.2 generic converter detected
usb 2-2: generic converter now attached to ttyUSB2
usbcore: registered new interface driver usbserial_generic
drivers/usb/serial/usb-serial: USB Serial Driver core
This is for loading the device; the next steps should introduce how to dial the data service. We
use the wvdial command as example.
3. Edit the wvdial configure file by typing the following command:
$sudo gedit /etc/wvdial.conf
On entering the above line a new window will pop up. Fill in the details as given below and
click save and close that window.
Edit the wvdial.conf file as follows:
[Dialer Defaults]
Init = ATZ
Init = ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
Modem Type = USB Modem
Baud = 115200
Modem = /dev/ttyUSB0
Phone = #777
Username = internet
Password = internet
Stupid Mode = 1
4. Do the wvdial to connect data service:
$sudo wvdial
This command will initialize the modem and connect you to internet.