
91
Brake and clutch pedal adjustment :
1. Ensure that clutch pedal height is the same as the brake pedal
height.
2. Connect the front end of the clutch cable to the clutch release lever
and adjust the cable by setting the nut by hand so as to get clutch
pedal height same as brake pedal height, and cable is tight.
3. Due to wear of the clutch disc, the pedal lever will lift up. Readjust
the pedal height again, using clutch cable.
Note :
Brake pedal height adjustment is required only in case of
component removal, etc. Adjustment is not required during normal
maintenance.
4. Adjust brake light switch, gap of 3 mm to be maintained as shown
in the fig. after loosening the lock nut on the switch. Tighten the
nut after adjustment. This should be done with brake pedal in
complete released condition.
Do not apply tightening force over the switch body/terminal
block as it may damage the switch. Electrical supply for brake
lights is 'ON' without ignition switch. Under normal condition
the switch shall be 'OFF' and the lights are not glowing.
Any improper adjustment may result in either brake grabbing
unneccessarily or spongy brakes.
MAINTENANCE & CAR CARE
Clutch & Brakes
Clutch Adjustment Nut
Brake Light Switch
Lock Nut
3 mm
Содержание Indica V2 LEi
