x6
30mm
x4
Top
4
Fit locking cams to base
Insert the 6 locking cams into the bottom of the base.
Note: you can identify the front edge of the base
because it has the cams a bit further from the edge.
This will help you in the next step.
4
Felt
protector
pads
IMPORTANT - Note the correct
direction of the base panel.
Fit the tray divider
Use the phillips key to tighten each locking cam
(turn clockwise to tighten).
3
Note correct
way up
Insert 4 locking cams into the tray divider.
Push each cam all the way into the hole.
Use the phillips key to rotate the locking
cams so the ‘+’ and ‘-’ face toward the end
of the panel.
Fit the tray divider to the side panel.
Use the phillips key to tighten the
locking cams.
Again, you can identify the top of the
tray divider because it has the cams
closer to the edge. Ensure the top of
the tray divider matches with the top
of the side panel. If you try to attach
the tray divider upside down the two
edges will not line up evenly.