Side panel
Back panel
2
Fit locking pins to front, back and side panels
Fit locking cams to the base support, side and back
panels.
Fit x 2 side panels and x 2 corner supports to back panel
Fit the base panel
-Lay the front, back and side panels face down on the floor
-Front panel - Screw x 5 locking pins into threaded holes, 2 at each end and one in the
middle
-Side panel - Screw x 2 locking pins into threaded holes on each side panel
-Back panel - Screw x 1 locking pin into threaded hole in the middle of the back panel
-Tighten all locking pins firmly
-Push each cam all the way into the hole. Use a screwdriver to
rotate the locking cams so the pointed end of the cross on the
cam points in the direction locking pins will insert from.
-Side panels - Insert x 2 cam locks into each side panel and rotate
to the correct positon
-Back panel - Insert x 4 cam locks into the back panel and rotate
to the correct position
-Base support - Insert x 2 cam locks into the base support and
rotate to the correct position
Note the pointed end of the cross on the cam locks must
point in the direction the lokcing pins will inserted from
Use a screwdriver to rotate cam
into correct alignment.
Repeat for each side panel
The corner support needs to be in positon in the back panel before
the side panel can be attached.
The corner support must be the correct way around with pro-
trudting plastic insert facing downwards.
- Hold the corner support in position against the back panel as per
the picture
- insert the locking pins on the side panel into the holes and cam
locks in the back panel
-Turn the cam locks with a screwdriver to lock them into the lock-
ing pins
- Repeat so both side panels are attached to the back panel
Slide the base into the grooves on the side panels and the
groove in the back panel.
1
2
3
4
