63
Prior to commissioning
Stopping brake
Interlock
Release:
Adjust driver seat
Relocation drive
The travel direction and the speed are controlled by means of
the steering wheel and the gas pedal. The speed is variably
adjustable.
Brush installation
Before inserting, please check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
Squeegee assembly
Filling the fresh water tank
• First, press down the brake pedal (1),
then the stopping brake (2).
Release the brake pedal, the ma
-
chine is interlocked.
• Press the braked pedal down to the
end.
The machine is released.
• Remove the key and actuate the stopping brake (page 63).
• Release the lever on the left side of
the driver seat and move the seat to
the desired position.
• Release the lever so that the driver
seat is fixed in the set position.
Check the interlock levers of the driv
-
er seat!
• Release the stopping brake (see page 63).
• Release the stopping brake.
• Switch on the machine (key switch).
The display lights up.
The battery indicator signals whether
or not the machine is ready for opera
-
tion (in case of fault, see page 69).
• Using the direction selector lever,
chose your travel direction ([1] for
-
wards / [2] backwards).
• Move the machine to the required destination and release
the gas pedal.
1
2
1
2
2
1
Attention:
Do not use brushes which have reached
their wear limit. The wear limit is indicated
by the length of the red bristle. Do not use
worn or contaminated pads. Use original
TASKI brushes only. Failure to observe
these instructions may result in inade
-
quate cleaning results or even floor dam
-
age.
• Remove the key and actuate the stopping brake.
• Lift up the tools towards the coupling.
• Turn the tools into the coupling; the
left tool in counter-clockwise direc
-
tion, the right tool in clockwise direc
-
tion.
The tools are coupled.
• Remove the key and actuate the stopping brake.
• Hold the nozzle in both hands and
position it such that the nozzle holder
lugs (1) fit into the nozzle cut-outs
(2).
• Slide the nozzle upwards until the in
-
terlocking clips (3) lock in place with
an audible sound.
• Assemble both suction hoses onto the suction nozzles.
Attention:
Max. permissible water temperature
60 °C/140 °F.
Diversey recommends using cold water
since hot water will adjust to the floor tem
-
perature as soon as it is in contact with the
floor. Thus there are no advantages to us
-
ing hot water.
• Remove the key and actuate the stopping brake.
• Fold the driver seat forwards and open the tank cover.
• Take out the dosing cup from the fresh water tank (Flex
-
tank).
• Fill water into the fresh water tank
(Flextank).
The mark indicates the maximum
permissible filling level.
1
1
2
2
3
EN