do
more
4. Remove excess dirt and dust from the mechanical surfaces of the Lamination
Ring as shown. The features around the ball bearings are difficult to clean.
Removing only the excess debris is sufficient.
5. Once the Lamination Ring is clean, re-install the O-ring by folding over the two
bayonet features as shown in figure 2. Push the O-ring down into the corner.
Cleaning Lamination Ring.
Clean Lamination Ring ready
for lubrication.
Installing lubricated O-ring.
Cleaning the Lamination Ring.
Applying lubricant to groove.
Lubricating features.
6. Use the Low Profile Wrist Lubricant to lubricate the bayonet and ball bearing
features as shown. Ensure the features are well coated in lubricant.
7. Clean the Lamination Ring. Remove residual grease and dirt from the detent
surfaces and inside the bayonet fitting.
8. Apply the Low Profile Lubricant to the groove of the Lamination Ring as shown.
A bead around the perimeter will suffice.
Low Profile maintenance and care guide
10
9
Low Profile maintenance and care guide
