OPERATING INSTRUCTIONS
ON/OFF Switch (Fig. 7)
The ON/OFF switch (1). A circuit breaker (2) is located below the switch.
To operate the shredder:
1. Plug the shredder into a properly
grounded 3-prong outlet.
2. Flip the switch (1) to the ON
position. If the shredder does not
start, flip the switch to the OFF
position and press the reset
button (2), then flip the switch to the
ON position.
3. Flip the switch (1) to the OFF
position to turn off the shredder.
Allow at least 5 seconds for the
blade to stop rotating.
Overload protection (Fig. 7)
This yard chipper has a reset overload feature. The reset button will restart the
motor after it shuts off due to overloading or low voltage. If the motor stops
during operation:
1.Turn the ON/OFF (1) switch to the OFF position.
2.Wait about five minutes for the motor to cool.
3.Push in on the reset button (2)
.
4.Turn the switch (1) to the ON position.
12
ALWAYS ALLOW 5 SECONDS OR MORE FOR THE
BLADE
TO STOPROTATING AFTER TURNING OFF THE CHIPPER.
TO PREVENT AN ACCIDENTAL START-UP IF THE RESET
BUTTON IS PUSHED,
THE ON/OFF SWITCH SHOULD BE IN THE OFF
POSITION AND THE PLUG SHOULD BE REMOVED FROM THE POWER
SOURCE WHILE COOL DOWN TAKES PLACE.
Fig. 7
1
2
OPERATION
WARNING
WARNING