ASSEMBLY INSTRUCTIONS
The chipper must be fully assembled before use.
Fig.3
BEFORE MAKING ANY ADJUSTMENTS.
10
TO AVOID INJURY, ALWAYS TURN THE SWITCH OFF
AND DISCONNECT THE CHIPPER FROM THE POWER OUTLET
BEFORE MAKING ANY ADJUSTMENTS.
Fig.1
Fig.2
Fig.3
1
2
3
5
4
6
7
8
1. Place one end of the axle (2) into the
hole on the leg (1) as shown in Fig.1
Spread legs slightly to allow the other
end of the axle into the opposite hole.
2. Place large washer (3) onto axle.
3. Place wheel (4) onto axle followed by
the small washer (5) and wheel nut (6)
as Fig.2.
4. Repeat steps 2 and 3 for the opposite
side.
5. Place the “L” wrench (7) through the
hole in the axle and then using the
14mm wrench (8), tighten each wheel
nut in turn, while holding the axle
steady with the “L” wrench.
WARNING
ASSEMBLY AND ADJUSTSMENTS