Task Force Tips ZCH1T1-OSC, Инструкция по установке

Страница: 6 / 24

©Copyright Task Force Tips LLC 2014-2018 6 LIZ-060 October 26, 2020 Rev03
3.4 PARTS IDENTIFICATION AND INTENDED ORIENTATION
Figure 3.4 identifies the typical functional components of the Booster. The Booster is intended to be installed in the orientation shown,
with the inlet flange facing towards the earth below. This orientation allows the monitor and Booster to fully drain after use, as described
in Section 5.3 .
Figure 3.4
3.5 OPTIONS, DIMENSIONS, AND WEIGHTS
Several options are available for valve control, monitor mounting, and the two LDH ports. Each option is described in Section 3.5.3
through Section 3.5.5 . The dimensions and approximate weights of the individual options can be added together to calculate the overall
size and weight of the Booster with the desired options installed, as shown in Table 3.5.1. All weights include supplied caps and
adapters.
3.5.1 MODEL NUMBERS AND SERIAL NUMBERS
Model numbers can be specified by combining 9 characters in the sequence shown below. The unique characters for each component
option are presented in Section 3.5.3 through Section 3.5.5 , along with the corresponding weights and dimensions. The model number
and unique serial number of each Booster are located on the label above the external automatic drain, as shown in Figure 3.4. Go to
tft.com/serial-number for additional information about this product.
Table 3.5.1
Character
Position
1 2 3 4 5 6
Component ZC
(same prefix for
all models)
SIDE A INLET OPTION
(3.65” I.D.)
LDH INLET PORT C3
(3.65” I.D.)
SIDE B OPTION
(monitor, 3.65” I.D.)
STYLE SIZE
Example Model # ZCF1T1 Character Sequence Weight (lb)
Booster Body: Same for all models prefix ZC same for all models 20.7
Side A Inlet: 4” ANSI 150 Flange Character “F” in position 3 + 7.7
Port C3 Style: Storz Character “1” in position 4
Port C3 Size: 5.0” Character “T” in position 5 + 3.2
Side B (monitor) CODE-RPM Direct Connection Character “1” in position 6 + 1.8
Net Weight: 33.4 lb (15.15 kg) = 33.4
Model number
Serial number
Shaft Cap
Automatic
water drain valve
(see section 5.3)
Side A Inlet
(see section 3.5.3)
Side B Outlet
(see section 3.5.5)
Clapper
position
indicator
Swing check valve
(clapper)
Bolt holes for
oscillator retrofit
Turbine port plug
for oscillator retrofit
LDH Inlet Port C3
(see section 3.5.4)
Automatic
water drain valve
Gear Box
Belt Tensioner
Safety Guard
Booster OSC
Pully Housing
Manual Overide (External OSC Drive)
Pull Pin
(Sweep Width Adjust)