©Copyright Task Force Tips, LLC 2002 - 2018
LIA-200 March 20, 2018 Rev19
7
4.6 CHANGING HANDWHEEL TO LEFT SIDE (RC MODELS)
STEP 1: Remove screws and end cover
STEP 2: Slide off both sprockets and chain as one unit.
STEP 3: Remove button head screw and lock washer to remove motor unit.
NOTE: Remove set screw that is in hole for the button head screw and reinstall the set screw on the other side.
The set screw plugs the hole to keep dirt from entering the gearbox.
STEP 4: Remove 4 screws and reposition motor so electric wire points in desired direction.
STEP 5: Change hand wheel to other side as in Section 4.3.
STEP 6: Reverse steps 1, 2 and 3 to reinstall motor on other side. Apply Blue Loc-Tite thread locking compound to all of the screw
threads.
STEP 7: Reverse polarity (direction) of motor by holding OPEN and CLOSE buttons together for 15 seconds.
STEP 5
STEP 2
STEP 1
STEP 4
STEP 3
4.7 BALL INTAKE VALVE RC MANUAL OVERRIDE
The Ball Intake Valve RC is motor driven but also has an override handwheel for operating the valve manually. The override
handwheel may also be used in the event of power failure. If electrical power is supplied to the control panel then the LED valve
position display will track the valve’s position as the handwheel is moved. If the handwheel is moved while there is no power to the
electric controls than the LED valve position display will be in error when the electric power is reconnected. The LED valve position
indicator will self correct the first time the valve is cycled under electric control.
If more compactness is desired the override handwheel may be removed. The drive shaft has a hex so a wrench or socket may be
used for manual override. If the manual override handwheel is removed assure that the correct size wrench of socket is available
in the event of power failure.
11/16” (18mm) Hex
