Page 16 of 22
4.a
Put the screws through the furthest set of mounting holes in the bay (making
sure the core and bays are securely mated together).
4.b
As the screws come out the backside of the bracket, attach the washers and
add the wing nuts.
5.
Confirm that the core and bay units are securely mated.
6.
Finish tightening all of the screws.
Step 3:
Identify EVIDENCE.com Dock Placement
Determine the best wall location for mounting the EVIDENCE.com Dock(s).
1.
Look for a location away from heat sources and direct sunlight that does not
obstruct movement.
2.
Choose a location close to an electrical outlet and a network outlet (Figure 10).
Measure the length of the EVIDENCE.com Dock’s power cord to be sure that it
will reach.
Step 4:
Attach the Wall Mount Bracket to the Wall (Stud mount)
Your EVIDENCE.com Dock Wall Mount Kit comes with hardware for mounting the
bracket to a stud or mounting directly into drywall. If you are going to install the
bracket to drywall, go to
Step 5: Attach the Wall Mount Bracket to the Wall (Drywall
mount)
.
Note:
Use the longer screw for mounting the bracket into a stud.
1.
Using a stud finder, mark the location of each stud’s center with a pencil.
1.a
Use a nail to confirm a stud has been located.
Note:
Depending on the wall construction, you may not be able to mount
both ends of the Wall Mount Bracket into the stud.
1.b
Use the drywall anchors in the EVIDENCE.com Dock Wall Mount Kit for the
other mounting locations if needed.
2.
Position the EVIDENCE.com Wall Mount Bracket on the wall and align the
mounting keyhole in the left side of the bracket with the center line of the stud.
2.a
Use a level to ensure the bracket is level before marking the holes.
2.b
Mark the center of the left side keyholes in the center of each wall stud.
2.c
Using a power drill, drill a pilot hole smaller than the screw diameter.
2.d
Install the screws into the stud until there is 1/8” [3.2 mm] of space between
the bottom of the screw head and the wall.
