Tasco POWER TRACE PTL610 Скачать руководство пользователя страница 9

MaDE In tHE usa BY:

TASCO, INC.

2895 West oxford avenue, #7

Englewood, colorado 80110

303-762-9952, 1-800-999-9952

www.tasco-usa.com

SPECIFICATIONS MODEL PTL610

TRANSMITTER:
operating Voltage: 9-600 Volts, ac/Dc
Power: line power or 9 volt battery
current: 8 ma avg.
Frequency: 15KHz
operating temp: 0ºF to 120ºF (-18º - 50ºc)
size: 3.75” x 2.5’” x 1”

RECEIVER:
Power: 9 Volt alkaline Battery (included)
range: up to 20 ft. from circuit
operating temperature: 0ºF to 120ºF 
(-18º - 50ºc)
size: 7.5” x 2’” x 1”

WARRANTY:

tasco, Inc. warrants that the Power trace

tM

 will be free from defects in workmanship and 

materials for a period of two (2) years from the date of purchase.
tasco, Inc. will, without charge, replace or repair, at its option any warranted product returned 
to the tasco factory service department.
tasco, Inc. shall not be liable for any consequential damages, including without limitation, 
damages resulting from loss of use or damages resulting from use or misuse of this product. 
some states do not allow limitations of incidental or consequential damages, so the above 
limitation or exclusion may not apply to you.
this warranty gives you specific rights and you may also have rights which vary from state 
to state.

EXCLUSIONS: 

this warranty does not apply in the event of misuse or abuse of the product or as a result of 
unauthorized repairs or alterations.

NOTICE TO PURCHASER:

all statements, technical information and recommendations contained herein are based on 
tests we believe to be reliable, but the accuracy or completeness thereof is not guaranteed, 
and the following is made in lieu of all warranties, express or implied: Manufacturer’s only ob-
ligation shall be to replace such quantity of the product proved to be defective. Manufacturer 
shall not be liable for any injury, loss or damage direct or consequential, arising from the use 
or misuse of this product. user shall determine the suitability of the product for his intended 
use, and user assumes all risk and liability in connection therewith. no statements or recom-
mendations not contained herein shall have any force or effect unless in an agreement signed 
by officers or the manufacturer.

Содержание POWER TRACE PTL610










Отзывы: