Tasco 119270CW, Инструкция по эксплуатации

Страница: 5 / 44

5
INSTALLING BATTERIES and SD CARD
Before you begin to use your Tasco Trail Camera, you will first
need to install a set of batteries and insert an SD card. Although
that may only take you a minute, there are some important
notes about both batteries and SD cards you should be aware
of, so please take the time to
read the following directions
and cautions:
Loading Batteries
Press the
Battery Tray Eject Button
to release the battery
tray and pull it out for loading (Fig. 2) . Switch the camera’s
power
OFF
when loading/unloading batteries. Be sure to insert
each battery so its polarity (+/- direction) matches the polarity
indications at the bottom of the battery tray. The camera is
capable of operating with only 4 batteries installed if necessary,
but a full set of 8 batteries should normally be used to ensure
the longest operating time. Tasco recommends using eight new
lithium AA (Energizer
®
brand) or alkaline AA batteries. NiMh
Rechargeable batteries can also be used, but they might have
a shorter life span due to their reduced efficiency over time and
at low temperature.
Inserting the SD Card
The Tasco Trail Camera uses a standard SD (Secure Digital)
memory card to save your photos (.jpg format) or videos (.avi
format) . SD and SDHC (
H
igh
C
apacity) class 4 or higher speed
cards, up to a maximum 32GB are supported.
• Make sure that the write-protect switch on the side of the
card is “off” (NOT in the “Lock” position). With the power
switch in the
OFF
position, insert the SD card in the slot
on the lower right side of the camera
(Fig. 3)
until it clicks
in place. If the wrong side of the card is facing up, you
will not be able to insert it without force-there is only one
correct way to insert cards.
• If the SD card is not inserted correctly, or no card is in
the slot, “ C A r d ” will appear on the LCD Display, and the
camera will not operate
(Fig. 4, next page)
. Other card
status display messages: “
F U L L
” indicates the card’s
memory is full, with no remaining room to store files (see
below)
. “
E r r
” means there is a card reading error (try a
different SD card).